Автозапчасти » FORD » 1990 » BRONCO II » 2.9L 177cid V6 » КПП / Редуктора / Привода » Карданный вал

Drive Shaft
Rear; 4WD; with GKN Conversion Design; with 30.24 (in) Long Driveshaft

Drive Shaft
Rear; RWD; Automatic trans.; with GKN Conversion Design; with 36.26 (in) Long Driveshaft

Drive Shaft
Rear; RWD; Manual trans.; with GKN Conversion Design; with 39.69 (in) Long Driveshaft

Drive Shaft
Rear; Manual trans.; with GKN Conversion Design; with 36.61 (in) Long Driveshaft

Drive Shaft
Rear; 4WD; Automatic trans.

Drive Shaft
Rear; 4WD; Manual trans.

Drive Shaft
Rear; RWD

Drive Shaft
Rear; 4WD; Manual trans.; GKN Conversion Design; w/ 32 11/16 In. Prop Shaft

Drive Shaft
Fits Rear; 4WD; Automatic trans.; GKN Conversion Designor Rear; 4WD; Manual trans.; GKN Conversion Design; w/ 30-1/4 In. Prop Shaft

Drive Shaft
Front; RWD; Automatic trans.; GKN Conversion Design; w/ 36-1/4 In. Prop Shaft

Drive Shaft
Rear; 4WD; Automatic trans.; 25-1/2 In. Length (Center of Joint to Center of Joint)

Drive Shaft
Rear; 4WD; Manual trans.; 36-5/8 In. Length (Flange to Flange or Center of Joint to Flange)

Drive Shaft
Rear; 4WD; Compressed Length of 30-1/4 in. measured from flange to flange; 4 bolt flange on each end; Conversion design replaces non rebuildable GKN CV design.

Drive Shaft
Rear; RWD; Manual trans.; Compressed Length of 39-11/16 in. measured from center to center of the furthest U-Joints, replaces GKN design shafts

Drive Shaft
Rear; 4WD; Automatic trans.

Drive Shaft
Rear; 4WD; Manual trans.; with 32.68" (830 mm) Long Driveshaft; with GKN Conversion Design