Автозапчасти » JEEP » 2002 » LIBERTY » 3.7L V6 » КПП / Редуктора / Привода » Карданный вал

Drive Shaft
Front; with 30.35 (in) Long Driveshaft

Drive Shaft
Front; Manual trans.; Conversion Shaft/Kit Includes New 32 Spline Transfer Case Yoke; w/ Sales Code DHN (Command-Trac Part Time 4WD System)

Drive Shaft
Front; Automatic trans.; w/Sales Code DHN (Command-Trac Part Time 4WD System)

Drive Shaft
Front; Manual trans.; Original Design; w/ Sales Code DHN (Command-Trac Part Time 4WD System)

Drive Shaft
Rear; 4WD; Automatic trans.

Drive Shaft
Rear; RWD; Automatic trans.; w/Sales Code DRJ (Dana M35/194 mm Rear Axle)

Drive Shaft
Rear; RWD; Automatic trans.; w/Sales Code DRA (Corporate 8.25 Rear Axle)

Drive Shaft
Rear; RWD; Manual trans.

Drive Shaft
Front; 4WD; Automatic trans.; 29.6 (in) Length

Drive Shaft
Front; Automatic trans.

Drive Shaft
Front; Automatic trans.; With Command-Trac Part Time 4WD System

Drive Shaft
Front; 4WD; Automatic trans.; With 19" Prop Shaft

Drive Shaft
Front; OE Tube length of 16.5 in. measured from weld to weld, Compressed Length 28.5 in. measured from flange to flange. Replaces OE# 52111596AB, 52111506AB, 52111594AA

Drive Shaft
Front; Manual trans.; Tube length of 19 in. from weld to weld; Replaces OE 52111591AA

Drive Shaft
Front; Selec-Trac Active Full Time 4WD; NV242 Transfer Case

Drive Shaft
Front; Manual trans.; w/ Command-Trac Part Time 4WD System

Drive Shaft
Front; Automatic trans.

Drive Shaft
Fits FRONT; w/ 19" LONG DRIVESHAFT; MEASUREMENT IS TAKEN BY MEASURING THE TUBE LENGTH ONLY. MEASURE FROM THE CENTERLINE OF THE WELD ON ONE END TO THE CENTERLINE OF THE WELD ON THE OPPOSITE END OF THE COLLAPSED PROP SHAFTor Front; w/ Auto Trans; MEASURE TUBE LENGTH FROM WELD TO WELD ON EACH END OF COLLAPSED SHAFT.; WITH 19" LONG DRIVESHAFT

Drive Shaft
Front; w/AUTO TRANS and 4WD/AWD, NV231 TRANSFER CASE (ID # ON LEFT SIDE OF CASE)

Drive Shaft
Front; Manual trans.; w/ Command-Trac Part Time 4WD System