Автозапчасти » JEEP » 2010 » LIBERTY » 3.7L V6 » КПП / Редуктора / Привода » Карданный вал

Drive Shaft
Front; 4WD; with 30.35" (771 mm) Long Driveshaft

Drive Shaft
Front; with 15-1/2" (393 mm) Long Driveshaft; Measure Tube Length from Weld to Weld on each end of collapsed shaft.

Drive Shaft
Rear; RWD; Automatic trans.

Drive Shaft
Front; 4WD

Drive Shaft
Rear; Steel Conversion Shaft; w/Sales Code DH2 (Selec-Trac II Active Full Time 4WD)

Rear; Command Trac II - Part Time 4WD, 3.7L V6 Engine; 4 Door

Front; 4 Door

Rear; Selec-Trac II Active Full Time 4WD, 3.7L V6 Engine; 4 Door

Drive Shaft
Front

Drive Shaft
Front; 4WD; 31.73" (806mm)

Drive Shaft
Rear; w/Auto Trans.

Drive Shaft
Front; 4WD/AWD

Drive Shaft
Front; Tube length of 19-1/4 in. from weld to weld, with NV140 transfer case; 30.3 in. Flange to Flange Collapsed; 6 Bolt CV head on each end.

Drive Shaft
Front; 4WD; Nominal length 31.5 in. measured from face of flange to face of CV Joint

Drive Shaft
Front; 4WD; Measurement is taken from the centerline of the U-Joint located at the slip yoke end to the centerline of the furthest U-Joint on the opposite end of the collapsed Prop Shaft; with 22" Long Driveshaft

Drive Shaft
Front; Measurement is taken by measuring the Tube length only. Measure from the centerline of the weld on one end to the centerline of the weld on the opposite end of the collapsed Prop Shaft; with 15-1/2" Long Driveshaft

Drive Shaft
Rear; Automatic trans.; w/Sales Code DHL (Command-Trac II Part Time 4WD)

Rear; 4-Spd. Automatic VLP 42RLE Trans, 3.7L V6; 4 Door

Front; 4 Door

Drive Shaft
Rear; 4WD; Automatic trans.

Drive Shaft
Rear; 4WD; Automatic trans.